Gas detector working(Point gas detector)

The detector comprises of a Transmitter and Receiver contained within one enclosure.

gd

The Transmitter emits an invisible infrared light beam that is reflected via a prism(s) mounted directly opposite and with a clear line of sight.The reflected IR light is detected by the Receiver and is analysed.Smoke in the beam path will reduce the received IR light proportionally to the density of the smoke.The detector analyses this attenuation, or obs curation and acts accordingly

Or

In some gas detectors, the point detector operates on a short fixed path (30 to 150 mm) between the IR light source and the light detector, assuming uniform concentration along this path. IR light is passed through a sample of the gas/vapor, and received at the sensor(s).

point gas detector

The active sensor is set in the absorption band of the gas being monitored, while the reference sensor is not. The ratio of the wavelengths is compared to determine if the gas/vapor is present.

To learn more about Instrumentation and Control, purchase your copy now

from amazon

 

25 thoughts on “Gas detector working(Point gas detector)

  1. Pingback: My Post till now | Kishore Karuppaswamy

  2. Pingback: All my posts till now | Kishore Karuppaswamy

  3. Pingback: A typical Foundation Field bus wiring diagram | Kishore Karuppaswamy

  4. Pingback: Flow transmitter DP type | Kishore Karuppaswamy

  5. Pingback: Instrumentation related to a motor driven pump | Kishore Karuppaswamy

  6. Pingback: Dampers | Kishore Karuppaswamy

  7. Pingback: I/P Converter | Kishore Karuppaswamy

  8. Pingback: Calibration of Temperature transmitter zero trimming | Kishore Karuppaswamy

  9. Pingback: Calibration of siemens sipart PS2 | Kishore Karuppaswamy

  10. Pingback: Temperature transmitter – RTD | Kishore Karuppaswamy

  11. Pingback: Painting Procedure | Kishore Karuppaswamy

  12. Pingback: Instrumentation Cable design specification | Kishore Karuppaswamy

  13. Pingback: Acceptable accuracy ranges of Instruments | Kishore Karuppaswamy

  14. Pingback: Standard Power supply requirements for Instrumentation devices | Kishore Karuppaswamy

  15. Pingback: General design requirements of Instrumentation part 2 | Kishore Karuppaswamy

  16. Pingback: General design requirements of Instrumentation part 3 | Kishore Karuppaswamy

  17. Pingback: General design requirements of Instrumentation part 4 | Kishore Karuppaswamy

  18. Pingback: AK ENCON ENGINEERING SERVICES | Kishore Karuppaswamy

  19. Pingback: Bastard Esterraj Stephen and MC GSN Raju | Kishore Karuppaswamy

  20. Pingback: Ultrasonic flow measurement working principle | Kishore Karuppaswamy

  21. Pingback: Boiler | Kishore Karuppaswamy

  22. Pingback: General design requirements of Instrumentation part 5 | Kishore Karuppaswamy

  23. Pingback: All my posts till now | kishore koduvayur

  24. Pingback: AS-i (Actuator sensor-Interface Protocol) | Kishore Karuppaswamy

  25. Pingback: Profibus | Kishore Karuppaswamy

Leave a Reply